A sound dairy shed design keeps cows dry, fed and calm on a small plot. Most Kenyan smallholders milk one to three cows under zero grazing, so the shed replaces the pasture. The cow stands, lies, eats and drinks inside one structure, and the structure must move water and manure out without help from rain. This guide walks the nine decisions in build order. It starts at the bare plot and ends at the water trough. Dimensions are planning ranges for Friesian and Ayrshire crosses, the common dairy breeds in Kenya. Confirm them against your own herd and site before you pour concrete.
Site and orientation in a dairy shed design
First, pick the highest ground on the plot. A pad above the surrounding field sheds storm water away from the floor instead of into it. Next, set the long axis east to west. The sun then rides over the ridge, and the open sides stay shaded through the hot hours. However, wind matters as much as sun. Face the open side away from the rain wind, which in most highland sites comes from the south east. Also, keep the shed downwind of the house, because smell travels. Leave a cart track wide enough for a fodder load and a milk pickup at the gate.
Finally, mark the manure pit downslope of the pad but above any well or stream. Clearing and levelling the pad is a separate job; our team treats it as earthworks, not building.
Space per cow and shed layout
Every dairy shed design starts from the cow count, not from the budget. A milking cow needs room to lie stretched out, plus a share of the feeding alley. Crowded cows lie less, and lying time drives milk yield. Therefore, plan the covered floor per head first, then add the alleys and the milking stall on top. The table gives working ranges for a tied or loose-housed zero-grazing unit.
| Cow class | Covered floor per head | Trough length per head |
|---|---|---|
| Milking cow | 8 to 10 m² | 0.7 m |
| Dry cow | 8 to 10 m² | 0.7 m |
| Heifer, 6 to 12 months | 4 to 6 m² | 0.5 m |
| Calf under 6 months | 2 to 3 m² | 0.3 m |
Planning ranges per head; add alleys, store and milking stall on top of the covered floor.
Behind the cows, leave a walkway 1.2 to 1.5 m wide so a barrow passes a lying cow. In front, the feeding alley takes the same width. A 6 by 12 m pad therefore carries four to six milkers, not twelve. Also, separate the feed store from the sleeping area, because dust and mould travel with hay.
Floor slope and drainage in a dairy shed design
A dairy cow drops roughly 30 to 50 litres of urine and wet manure a day. The floor must move that liquid out without a brush. So cast concrete with a fall of 2 to 3 percent toward an open drain at the low edge. Groove the surface lightly, because smooth concrete slips when wet and a split cow ends her lactation.
Next, cut a shallow urine channel behind the standing line, and slope it the same way. The channel joins a drain 20 to 30 cm wide that runs outside the wall. However, never let the drain discharge beside the pad. Pipe or channel it to the manure pit, and keep the pit lined so seepage stays out of the soil water. In heavy clay sites, add a soak pit at the pit overflow, because clay takes water slowly.
Feeding alley and trough dimensions
Zero grazing means all feed arrives by cart or wheelbarrow. Therefore, size the feeding alley for the loaded cart, not for a person: 1.2 to 1.5 m clear width, with a turning space at the end. Set the trough floor 15 to 20 cm above the cow floor so hooves and urine stay out of the feed. A trough face 0.7 m long per cow stops the boss cow from eating two rations. Also, keep the feed face smooth, because rough concrete skins the neck.
Chopped Napier and maize stover pass a chaff cutter before they reach the trough, and our chaff cutter page lists the models the shop stocks. For a mixed ration, the animal feed mixer guide covers the checks before purchase, and the shop carries the mixer itself. Place the water trough at the other end of the alley, so wet feed and drinking water stay apart.
Milking area and cow flow
Milk is food, so the milking stall sits away from the manure path. Allow a stall about 3 by 2 m with a washable floor and its own drain. Next, give it a clean water point and a shaded milk store, because warm milk sours fast. Then fix the cow flow as a one-way loop: lie, feed, milk, out. A dairy shed design fails quietly when cows cross paths at the gate, because the herd baulks and milking time doubles. However, a loop needs space, so on a tight plot run the loop as a straight line with a return gate at the far end. Keep the stall floor grooved like the rest of the shed.
Roof and ventilation in a dairy shed design
Heat cuts feed intake before it cuts milk, so the roof is a production input. Set the eaves at 2.5 to 3 m and leave an open ridge gap of about 30 cm, because hot air must escape at the top. Half-walls of 1.2 m with open space above give cross wind without draught at cow level. However, iron sheets radiate heat downward at midday.
In cold highland sites, hang curtains on the open side for the night, because calves chill fast. Therefore, treat shade and ventilation as one decision in a dairy shed design, not as two purchases.
Water store and troughs for a dairy shed design
A milking cow drinks 60 to 100 litres a day, and she drinks it in minutes after milking. So the trough must refill faster than the herd empties it. The table sets the daily store per head.
| Animal | Water per day | Trough space per head |
|---|---|---|
| Milking cow | 60 to 100 L | 0.6 m |
| Dry cow | 30 to 50 L | 0.6 m |
| Heifer | 20 to 30 L | 0.4 m |
Daily drinking water and trough frontage per head; size the store for the whole herd.
A 5,000 litre tank on a steel tower 2 to 3 m above the trough gives gravity flow with no pump running all day. The PVC pipe page lists the sizes for the gravity line between tower and trough.. Also, fit a float valve in each trough, because an open pipe wastes the store overnight. Scrub troughs weekly, because algae film cuts intake. A dairy shed design without a raised store ends with a pump and a fuel bill.
Parts the shop stocks for a dairy shed design
The shed is civil work, but four of its inputs are catalogue items. The table ties each need to a live shop page, and each linked page lists the sizes and price it stocks. Rows with no matching product stay plain, with the reason stated.
| Shed need | Shop item | Where it fits |
|---|---|---|
| Chopped fodder | Chaff cutter | Feed store, before the trough |
| Mixed ration | Animal feed mixer | Feed store, batch mixing |
| Water line to troughs | PVC pipe | Tower to trough, gravity line |
| Water tank | – | tower built on site |
| Concrete trough | – | Cast on site with the floor |
Four catalogue inputs for the shed; tank and trough are sourced or cast outside the shop.
For pipe sizes and fittings beyond this table, the irrigation equipment suppliers page lists what the shop holds and how to check it before payment.
Common dairy shed design mistakes
Five errors repeat on failed units. First, a flat floor, which holds urine and breeds hoof rot. Second, eaves under 2.2 m, which trap heat at cow height. Third, a feeding alley narrower than the cart, which forces feed over the wall. Fourth, no drain outside the wall, which turns the pad into a swamp in the rains. Fifth, a tank at ground level, which leaves the trough dry at peak drinking.
However, the most expensive error sits outside the shed: no exercise yard. Cows need daylight and movement, so fence a small yard beside the pad; our farm fence installation page covers the posts and wire. A dairy shed design that skips the yard trades milk for vet bills.
Frequently Asked Questions
How many cows fit a 6 by 12 metre shed?
The pad gives 72 m². After alleys, store and milking stall, plan four to six milking cows. Heifers and calves need their own pen, not spare corners.
Which roof direction is best in Kenya?
Run the long axis east to west. The open sides then face north and south, and midday sun stays off the cows.
Do I need a concrete floor?
Yes for dairy. Earth floors hold urine and manure, and wet bedding raises mastitis and hoof disease. Concrete with a fall cleans with a hose.
How high should the water tank sit?
Set the tank base 2 to 3 m above the trough rim. That head fills troughs by gravity and keeps flow up when the whole herd drinks at once.
Where does the manure go?
To a lined pit downslope of the pad, covered against rain. Composted manure feeds the fodder plot, and our irrigation in Kenya hub covers watering that plot through the dry months. See also the wider context on dairy cattle and zero grazing.
